22
2022
-
11
Maintenance of the punching boat
Author:
Maintenance of outboard engines should generally be divided into three parts: one is the maintenance of the engine in use; the second is the cleaning and maintenance after use; the third is the maintenance in the daily.
Maintenance of outboard engines should generally be divided into three parts: one is the maintenance of the engine in use; the second is the cleaning and maintenance after use; the third is the maintenance in the daily.
Maintenance in the work
1 engine in the starting work, pay attention to the following two tasks.
Strict engine operation regulations, in the start, stop the operation steps to correct, formal.
When the engine is working and running, do not disassemble and install any parts of the engine, and do not touch any high voltage and electrically charged working parts.
2 Use the correct fuel according to the regulations and configure the ratio of oil mixture correctly (25:1 for new machines and 50:1 for old machines).
3 to warm up the engine, so that the engine is warmed up, requiring the engine to start, generally low-speed operation for 2-3 minutes, so that the internal parts of the engine can fully supply oil to achieve good performance.
4 break-in operation: break-in operation is the first step in the new machine start, each new engine start before starting work, should be run for break-in. Make the machine parts fully break-in oil, to achieve a good working condition. Break-in time is usually 10 hours.
5 When the engine is running at high speed, it should not shift gears at will to prevent damage to the gears, and should reduce the throttle and shift gears after reducing the speed.
6 After shutting down, if the boat is located in the water, the engine should be lifted and the top position pin should be topped to prevent the propeller from being damaged by collision.